Toshiba nv Series Instruction Manual page 35

■DeviceNet state display LED
Indicates the status of the DeviceNet function. The contents of the display are as follows.
Name
Network Status (NS)
Module Status (MS)
Scanner Mode (Mode)
■DeviceNet configurator tool port (CONFIG)
CONFIG port is to connect the HMS configurator tool and set the slave I/O of DeviceNet. For details, refer to
"Chapter 4."
■DeviceNet data rate and node address setting switch (BAUD / MAC)
Set the data rate of DeviceNet and the node address of DN912. Refer to Chapter 4 for the setting.
■DeviceNet communication connector
Connect the DeviceNet communication cable. See Chapter 3 for wiring.
Table 2-3 DeviceNet state display LED
State Meaning
Off Not powered, not on line
Green On line, one or more connections established
Green, flashing On line, no connections established
Red Critical link failure
Red, flashing One or more connections timed out
Alternating Red / Green Device self-test in progress
Off No power
Green Normal operation
Green, flashing Auto baud in progress
Red Major fault
Red, flashing Minor fault
Alternating Red / Green Device self-test in progress
Off No power
Green Run mode
Green, flashing Idle mode
Unified Controller nv Series DeviceNet Module DN912 Instruction Manual
2.2 Functions of parts
19