Table of Contents
Advertisement
Product Overview
Specifications
Note:
Specifications and design are subject to
change without notice.
Width
1.56 m (61-5/8 inches)
of Cut
Height
Adjustable from 25 to 102 mm (1 to 4 inches) in 13
of Cut
mm (1/2 inch) increments
Blade
15,480 ft/minute @ 3250 engine rpm
Tip
Speed
Cutting
3 heat-treated steel blades, each 4.8 mm (3/16 inch)
Blades
thick and 55 cm ( 24-3/4 inches) long
Castor
203 mm (8 inch) diameter greaseable roller bearings
Wheels
(inflated to 241-345 kPa [35-50 psi])
Drive
PTO driven gearbox transmits power through a "AA"
System
section belt to all blade spindles.
Net
244 kg (539 lb)
Weight
Attachments/Accessories
A selection of Toro approved attachments and
accessories is available for use with the machine
to enhance and expand its capabilities. Contact
your Authorized Service Dealer or authorized Toro
distributor or go to www.Toro.com for a list of all
approved attachments and accessories.
To ensure optimum performance and continued safety
certification of the machine, use only genuine Toro
replacement parts and accessories. Replacement
parts and accessories made by other manufacturers
could be dangerous, and such use could void the
product warranty.
Operation
Note:
Determine the left and right sides of the
machine from the normal operating position.
Adjusting the Height of Cut
The height of cut is adjustable from 25 to 102 mm
(1 to 4 inches) in 13 mm (1/2 inch) increments, by
adding or removing an equal number of spacers on
the front and rear castor forks. The height-of-cut chart
below gives the combinations of spacers to use for
all height-of-cut settings.
Height-of-Cut
Setting
25 mm (1 inch)
38 mm (1-1/2
inches)
51 mm (2 inches)
64 mm (2-1/2
inches)
76 mm (3 inches)
89 mm (3-1/2
inches)
102 mm (4 inches)
1.
Start the engine and raise the cutting unit so that
the height of cut can be changed.
2.
Stop the engine after raising the cutting unit.
Adjusting the Front Castor Wheels
1.
Remove the tensioning cap from the spindle
shaft and slide the spindle out of the front castor
arm
(Figure
9).
12
Spacers Below Castor Arm
Front
Rear
0
0
1
1
2
2
3
3
4
4
5
5
6
6
Advertisement
Table of Contents
