Toro Groundsmaster 200 Operator's Manual page 13

1. Front castor wheel
2. Tensioning cap
2. Remove the washer from the spindle shaft.
3. Slide the spacers onto the spindle shaft to get
the desired height of cut, then slide the washer
onto the shaft.
4. Push the castor spindle through the front castor
arm.
5. Install the other thrust washer and remaining
spacers onto the spindle.
6. Install the tensioning cap to secure the assembly.
Adjusting the Rear Castor Wheels
1. Remove the tensioning cap securing the gage
wheel to the cutting unit brackets
Figure 9
3. Spacers
4. Thrust washers
(Figure
g010786
1. Rear castor wheel
2. Tensioning cap
2. Remove or add "C" shaped spacers at the
narrow portion of the spindle shaft, below the
castor arm, to get the desired height of cut.
Note:
spacers, contact the top and bottom of the
castor arm.
3. Install the tensioning cap to secure the assembly.
Note:
the same height of cut.
10).
13
Figure 10
3. Spacers
4. Thrust washers
Ensure that the thrust washers, not the
Ensure that all 4 castor wheels are set at
g010787