7. Secure the lift cylinders to the lift arms using the
supplied lift cylinder pins, carriage bolts, and nuts
(Figure 3).
8. Turn off the traction unit, and lower and secure the
operator platform.
4
Installing the Cutting Unit on
the Lift Arms
Parts needed for this procedure:
4
Thrust washer
4
Clevis pin
2
Hairpin cotter
2
Height-of-cut collar
2
Clevis pin
2
Hairpin cotter
Procedure
1. Move the cutting unit into position in front of the
traction unit.
2. Turn on the traction unit's ignition and move the
cutting unit to the float position. Push a lift arm
down until the holes in the lift arm line up with the
holes in the castor arm bracket and the height of cut
rod can be inserted into the lift arm pads (Figure 4).
3. Secure the lift arm to the castor arm with 2 thrust
washers, a clevis pin and a hair pin cotter. Position
the thrust washers between the lift arm and the castor
arm bracket (Figure 4). Insert end of cotter pin into
the slot in the castor arm tab to retain cotter pin.
4. Repeat the procedure on the opposite lift arm.
5. Start the traction unit and raise the cutting unit.
6. Push down on the rear of the cutting unit and insert
the height of cut rods through the lift arm pads.
7. Install the height of cut collars onto the height of
cut rods and secure with the clevis pins and hair pin
cotters (Figure 4).
8. Lower the deck and switch the traction unit ignition
switch to the off position.
1
7
6
g017950
1. Lift arm
2. Castor arm bracket
3. Height-of-cut rod
4. Lift arm pads
5. Thrust washers
5
Connecting the Hydraulic
Drive
No Parts Required
Procedure
Important: For your safety the cutter valve electrical
connector has been disconnected to disable the
operation of the cutter drive. Reconnect the
electrical connector once all hose line connections
have been made correctly.
9
10
8
9
5
3
Figure 4
6. Clevis pin
7. Hairpin cotter
8. Height-of-cut collar
9. Clevis pin
10. Hairpin cotter
4
2