Table of Contents
Advertisement
2. PRINTER SETUP
2.8.1 Self Print Test and
Dump Mode (Cont.)
ENGLISH VERSION EO1-33099
[INFORMATION]
INFORMATION
TOTAL FEED1
TOTAL FEED2
TOTAL PRINT
TOTAL CUT
[RS-232C]
BAUD RATE
BIT
STOP BIT
PARITY
FLOW
[LAN]
IP ADDRESS
SUBNET MASK
GATEWAY
MAC ADDRESS
DHCP
DHCP CLIENT ID
DHCP HOST NAME
SOCKET COMM.
SOCKET PORT
The test print content are different based on the emulation mode. The list
below is for TPCL mode.
PROGRAM VERSION ------------------------
TPCL VERSION --------------------------------
CG VERSION -----------------------------------
CHINESE VERSION---------------------------
CODEPAGE VERSION -----------------------
BOOT VERSION -------------------------------
KERNEL FONT VERSION -------------------
WLAN MODULE ------------------------------ WLAN module installation flag
BLUETOOTH MODULE --------------------- Bluetooth module installation flag
HW DETECT ------------------------------------ Hardware detection flag
TONE ADJUST(T) ----------------------------- Reserved parameter
TONE ADJUST(D) ----------------------------- Print tone fine adjustment value
FEED ADJUST---------------------------------- Print position fine adjustment value
CUT ADJUST ----------------------------------- Reserved parameter
BACKFEED ADJUST ------------------------- Back feed amount fine adjustment value
X-COORD. ADJUST --------------------------- X-coordinate fine adjustment value
CODEPAGE ------------------------------------- Character code selection
ZERO SLASH ----------------------------------- Font "0" selection
FEED KEY--------------------------------------- [FEED] key function setting
EURO CODE ------------------------------------ Euro code setting
CONTROL CODE ------------------------------ Control code type
MAXI CODE SPEC. --------------------------- Maxicode specification setting
SENSOR SELECT ------------------------------ Sensor type
PRINT SPEED ---------------------------------- Print Speed
FORWARD WAIT ----------------------------- Forward feed standby after issue
AUTO CALIB. ---------------------------------- Automatic calibration setting
E2-
11
[B-FV4D-GL14-QM-R]
[2305M000001]
[0.00km]
[00000cm]
[0000.0inch]
[0.00km]
[0]
[9600]
[8]
[1]
[None]
[XON/XOFF]
[192.168.010.020]
[255.255.255.000]
[000.000.000.000]
[ab-cd-ef-01-23-45]
[ON]
[FFFFFFFFFFFFFFFF]
[FFFFFFFFFFFFFFFF]
[
]
[
]
[ON]
[9100]
Firmware version
2.7 Loading the Media
Advertisement
Table of Contents
