Table of Contents
Advertisement
2. PRINTER SETUP
2.7 Loading the Media
(Cont.)
NOTES:
1. Media path
Transmissive Sensor
Platen
2. Make sure that the print side
faces up.
3. Cut the leading edge of the media
straight with scissors.
NOTE:
Be careful not to squeeze the
media with the Media
Guides. Doing so bends the
media, which can cause a
paper jam or feed failure.
ENGLISH VERSION EO1-33099
2. Press the Media Roll Holder Lever down and outward, set the media
between the Media Roll Holders ensuring that the printing side is
facing up. Release the Media Roll Holder Lever to clamp the media
roll securely.
Media Roll Holder Lever
3. Pass the media through the Media Guides. Pull the media until it reaches
the front of the printer.
Media Guide
E2-
8
2.8 Self Print Test and Dump Mode Utilities
Media Guide
Advertisement
Table of Contents
