Crushed Glass Installation (see manual for additional details).
Do not allow the crushed glass to block the air slots or to become too thick (maximum 1
layer deep on the burner). Failure to properly install glass may lead to sooting and
improper burning.
Before installing the crushed glass, make sure the pilot guard is in place (it is zip-tied to the glass tray – remove and discard
the zip-tie). After installing the glass, remove the pilot guard. Make sure no glass covers the pilot opening.
Pilot Guard
Disperse the crushed glass evenly along the glass tray.
Make sure the two air channels are free of crushed glass. Use the glass frame tool (or screwdriver) to clear this area.
Make sure the glass is only 1 layer deep on the burner.
Page 11 of 12
4415 HO ST - Driftwood Log Set
Installation Instructions
Quantity of Crushed Glass
17602107
(SKU 94500976)
4415HO
4 lbs. (1.8 Kg)
Remove pilot
guard after
placing glass
— 12/12/19
© Travis Industries, Inc.