Pre-Install Preparation - Cisco Meraki MR36H Installation Manual

Table of Contents

Advertisement

31/01/2022, 19:00
Orange - AP is booting (permanent Orange suggests hardware issue)
Blinking Orange - AP can't nd uplink 
Rainbow - AP is initializing/scanning
Blue - AP in Gateway mode with clients 
Blinking Blue - AP is upgrading
Green - AP in Gateway mode with no clients
Ethernet Status
The MR36H features four green Ethernet status LEDs near the bottom of the faceplate. When an Ethernet
client is connected, the LED will shine through the faceplate if Run Dark mode is not enabled. 
Run Dark Mode
The MR36H may be operated in "Run Dark" mode for additional security and to reduce the visibility of the
access point. In this mode, the LED will not be illuminated. This mode may be
dashboard.
 
When a MR36H is rebooted with rundark mode enabled, an orange LED will illuminate during boot then all
lights will be turned off after boot.
Safety and Warnings  
These operations are to be taken with respect to all local laws. Please take the following into consideration for
safe operation:
Power off the unit before you begin. Read the installation instructions before connecting the system to the
power source. 
Before you work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar
with standard practices for preventing accidents.
Read the wall-mounting instructions carefully before beginning installation. Failure to use the correct
hardware or to follow the correct procedures could result in a hazardous situation to people and damage to
the system.
This product relies on the building's installation for short-circuit (overcurrent) protection. Ensure that the
protective device is rated not greater than: 15 A, 125 Vac, or 10A, 240 Vac.
Please only power the device with the provided power cables or standard PoE to ensure regulatory
compliance.

Pre-Install Preparation

How can we help you?
https://documentation.meraki.com/MR/MR_Installation_Guides/MR36H_Installation_Guide
MR36H Installation Guide - Cisco Meraki
con gured
through the Meraki
8/21

Advertisement

Table of Contents
loading

Table of Contents