Copy Settings From Another Location; Set Location Alarms; Remove A Location; Change The Order Of Locations - Hach MET ONE 3400 User Manual

• Set the sample hold time between count cycles.
• Set the sample delay time to allow delay before the sample test begins.
7. Push RETURN to go back to the Add Sample Location screen.

Copy settings from another location

1. On the Counter Navigation screen, push LOCATIONS.
2. On the Area/Location Setup screen, select the area that includes the destination location.
3. Select the location where the copied settings should go. Push
4. Push YES to confirm or push NO to cancel.

Set location alarms

The particle counter allows different alarm settings for individual locations.
Note: Use this feature when the Use Location Settings is selected in Group Settings.
1. On the Counter Navigation screen, push LOCATIONS.
2. On the Area/Location Setup screen, select an area.
3. Select a location within the area. Push ADD LOCATION or EDIT LOCATION as needed.
4. In the Sample Location Setup screen, push ALARMS. The Alarm Settings screen has two tabs to
configure.
5. In the Count tab:
• Edit the particle size
• Edit particle concentration limits
6. In the Environment tab:
• Enable the temperature alarm and set temperature limits.
• Enable the relative humidity alarm and set relative humidity limits.
• Enable the air velocity alarm and set air velocity limits.
Note: These settings are only valid with the specific environmental probe attached to the instrument.
7. Push RETURN to confirm and go back to the Add Sample Location screen.

Remove a location

1. On the Counter Navigation screen, push LOCATIONS.
2. On the Area/Location Setup screen, select an area.
3. Select a location. Push REMOVE LOCATION.
4. Push YES to delete the location or push NO to cancel.

Change the order of locations

Change the listed order of locations to change the sample order during testing.
1. On the Counter Navigation screen, push LOCATIONS.
2. On the Area/Location Setup screen, select an area.
3. Select a location. Push the UP or DOWN arrow to change the position of the location in the list.
4. Continue to select and move locations to create the needed order for samples.
Note: Arrow keys can also be used to move a location to a different area.
26 English
.