Output Terminals; External Power Supply Input Terminals; Serial Communication Terminals - YASKAWA FP65U T Series Installation & Primary Operation

■

Output Terminals

Refer to Table 11.2 and Table 11.3
Type Terminal
N.O. output
MA
(Fault)
Fault Relay
N.C. output
Output
MB
(Fault)
MC Digital output common
M1
MFDO
(During Run)
M2
M3
MFDO
(Zero Speed)
M4
MFDO
N.O. output
MD
(Speed Agree 1)
N.C. output
ME
(Speed Agree 1)
MF Digital output common
Type Terminal
MFAO 1
FM
(Output frequency)
MFAO 2
Monitor Output
AM
(Output current)
AC Monitor common
External Power
+P External power supply
Supply Output
■

External Power Supply Input Terminals

Refer to Table 11.4 for a list of the functions of the external power supply input terminals.
Type
External Power Supply Input
Terminals
■

Serial Communication Terminals

Refer to Table 11.5 for a list of serial communication terminals and functions.
YASKAWA TOEPC7106171GA FP605 Drive Installation & Primary Operation
for a list of output terminals and functions.
Table 11.2 Control Circuit Output Terminals
Name (Default)
Table 11.3 Control Circuit Monitor Output Terminals
Name (Default)
Table 11.4 External Power Supply Input Terminals
Terminal Name (Default)
PS External 24 V power supply input
AC External 24 V power supply ground
Function (Signal Level)
Drive Fault Signal Output
• Relay output
• 30 Vdc, 10 mA to 2 A
• 250 Vac, 10 mA to 2 A
• Minimum load: 5 V, 10 mA (Reference value)
Multi Function Digital Output
• Relay output
• 30 Vdc, 10 mA to 2 A
• 250 Vac, 10 mA to 2 A
• Minimum load: 5 V, 10 mA (Reference value)
Note:
Do not set functions that frequently switch ON/OFF to MFDO (M1 to M4) because this will
decrease the performance life of the relay contacts. Yaskawa estimates switching life at
200,000 times (assumes 1 A, resistive load).
Multi Function Digital Output
• Relay output
• 30 Vdc, 10 mA to 2 A
• 250 Vac, 10 mA to 2 A
• Minimum load: 5 V, 10 mA (Reference value)
Function (Signal Level)
Multi Function Analog Output
Select voltage or current output.
• 0 V to 10 V/0% to 100%
• 4 mA to 20 mA (receiver recommended impedance: 250 Ω)
Note:
Select with jumper switch S5 and H4-07 [Terminal FM Signal Level Select] or H4-08
[Terminal AM Signal Level Select].
0 V
Power supply for external devices.
• 24 V (150 mA maximum)
Supplies backup power to the drive control circuit, keypad, and option board.
21.6 VDC to 26.4 VDC, 700 mA
0 V
11 Drive Start-Up Procedure
Function
47