Effect Settings - Casio Privia MA1003-A User Manual

Editing Zone Parameters
■ 6-B Vibrato Depth (VbDpt)
This item is for adjusting the depth
(strength) of vibrato applied to notes. A
larger negative absolute value makes vibrato
shallower, while a larger positive value makes it
deeper.
*
–64 to 0 to +63
■ 6-C Vibrato Delay (VbDly)
This item is for adjusting the time until
vibrato starts to be applied to a note. A
larger negative absolute value makes the time it takes
before vibrato is applied after a note is played shorter,
while a larger positive value makes it longer.
*
–64 to 0 to +63
■ 6-D Vibrato Waveform (WvFrm)
This item is for selecting the waveform when
applying vibrato to notes. You can select
from among the following waveforms.
*
––
Original (Org )
Sine (Sin)
Triangle (Tri)
Saw Up (SUp)
* "Org" is the initial default setting for all tones. The
actual default waveform type depends on the tone.
E-32
INT / EXT
INT / EXT
INT
Saw Down (SDw)
Pulse 1:3 (P13)
Pulse 2:2 (P22)
Pulse 3:1 (P31)

Effect Settings

For details on the meanings of the settings in this
section, see the flowchart under "Master Control
Configuration" (page E-4).
■ 7-A Reverb Send (RvbSd)
Specifies how much of the signal from
the sound source is sent to reverb.
*
0 to 127 ( default setting depends on the tone)
■ 7-B Chorus Send (ChoSd)
Specifies how much of the signal from
the sound source is sent to chorus.
*
0 to 127 ( default setting depends on the tone)
■ 7-C Acoustic Resonance Send (AReso)
Specifies how much of the signal from the
sound source is sent to acoustic resonance.
*
0 to 127 ( default setting depends on the tone)
■ 7-D DSP ON/OFF (DSP)
Switches DSP for each zone on or off.
Selecting OFF disables DSP for that particular
zone.
*
OFF, ON
The DSP of this Digital Piano can be used
simultaneously for up to two parts. Each part ("Sound
Source Configuration", page E-5) has a DSP priority,
which determines which of the two parts that have
DSP turned on should have the DSP effect applied. The
following shows the priorities assigned to each part.
Priority Part Number
1 Part 1
2 Part 3
3 Part 2
4 Part 4
5 Part 17 to 48
To apply a DSP to one or two lower priority parts
(Lower2, for example), turn off DSP ON/OFF for the
higher priority parts (Upper1, Lower1, Upper2).
INT / EXT
INT / EXT
INT
INT
Part Name
Upper1
Lower1
Upper2
Lower2
Song01 to Song16,
Ext01 to Ext16