Status Indicator; Stopping Or Changing A Program; If You Want To Load More Dishes; If The Dishwasher Is Turned Off Due To A Power Failure - Asko DWCBI331.W Operating Instructions Manual

Table of Contents

Advertisement

Using the dishwasher

Status indicator

The status indicator on the front display provides information by means of different colours.
Blue - Load more
The program has started, but you can still load more dishes.
Red - Do not load
You should not load more dishes (risk of poorer dishwashing result).
A flashing light indicates that the door has been opened while a program is in progress. If it flashes
when the door is closed, an error has occurred. See the chapter Troubleshooting.
Green - Unload
The dishwashing program is finished. The status light stays on for 15 minutes.

Stopping or changing a program

If you want to change program after starting the dishwasher, open the door then press and hold
Start/Stop for three seconds. Add more detergent if the lid of the detergent dispenser has opened
(this happens automatically if an automated dosage system has been connected). Then select a
new program, press Start/Stop and close the door.

If you want to load more dishes

Open the door. The dishwasher stops automatically. Add the dishes and close the door. After a
while, the dishwasher continues the program.

If the dishwasher is turned off due to a power failure

If the dishwashing program was not finished, the interrupted program continues when power is
restored.
NOTE!
During drying, the program is interrupted if the power is cut or the door is open for more than 2
minutes.

Once the program has finished

Once the program has finished, "END" appears on the display.
At the end of the program one short signal will sound. Chapter Settings describes how to change
this function.
The dishwasher switches off automatically after the program ends. Shut off the water tap after each
use.

How to get the best drying results

Fully load the dishwasher.
Angle dishes with hollows, such as cups, so that the rinse water will run off. This is also important
for plastic items.
Top up with rinse aid or increase the rinse aid dosage level.
Activate the Auto Open setting.
Allow the dishes to cool before unloading the dishwasher.
20

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dwcbi331.s

Table of Contents