Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Asko DWCBI241.S.AU
Summary of Contents for Asko DWCBI241.S.AU
- Page 1 OPERATING INSTRUCTIONS Dishwasher DWCBI241...
-
Page 2: Table Of Contents
Open the door and press the main power switch. "Welcome to your new ASKO. This is a first time set up." is shown on the display the first time the dishwasher is switched on. It is important that you choose the right settings to ensure good dishwashing results. See page 4. -
Page 3: Safety Instructions
Safety instructions Read the operating instructions and keep WARNING! them in a safe place! Knives and other pointed items must be placed Number of place settings: 14 with the points down in the cutlery basket or Never use the dishwasher for any purpose horizontally in other baskets. -
Page 4: Before Washing For The First Time
Open the door and press the main power switch. soft water (water with low mineral content). Hard water leaves a white "Welcome to your new ASKO. This is a first time set up." is shown coating on dishes and the dishwasher. -
Page 5: Loading The Dishwasher
Loading the dishwasher Greener dishwashing Water hardness 0/1/2/3/4/5/6/7/8/9 Do not rinse under running water Adjusting the water softener. Select a setting depending on the Simply scrape off large food particles before loading the dishwasher. hardness of the water supply. It is important that this setting is correct! Do not forget to put salt in the salt compartment after you have set Choose a green detergent the water softener to 1 - 9. - Page 6 Fragile dishes The dishwasher's baskets Some cookware is not dishwasher safe. This can be for several reasons. The dishwasher is equipped with an upper basket and a lower basket Some materials cannot withstand strong heat, others can be damaged with a cutlery basket. by dishwashing detergent.
- Page 7 The wine glass shelf is placed in the rear section of the lower basket. This accessory can be purchased by calling ASKO. Accessory Buy an extra cutlery basket. The extra cutlery basket is flexible and can be dismantled and attached to the lower basket or the large cutlery basket to make an extra large cutlery basket.
-
Page 8: Using The Dishwasher
Using the dishwasher Add detergent NOTE! Use only dishwasher detergent! Washing up liquid must not be used Press to open as the foam that forms prevents the dishwasher from operating effectively. Dishwasher tablets Halve the tablet if it is difficult to close the dispenser lid. There is a risk that the detergent will not be released properly if the lid is tight and will not open correctly. - Page 9 Open the door and press the main power switch. Starting the dishwasher START STOP 2:00 2:15 58°C Speed mode Select the program Select from more programs Self-cleaning The main power switch Self-cleaning programme for hygienic cleaning of the dishwasher tub, spray arms and spray pipes.
- Page 10 Red - Do not load At the end of the program, you will hear a short beep. Chapter Settings describes how to change this function. You should not load any more dishes (risk of poorer dishwashing result). The dishwasher switches off automatically after the program ends. Flashing red indicates a problem.
-
Page 12: Settings
Settings Open the dishwasher's Settings menu Open the door and press the main power switch until the display lights up. To open the dishwasher's Settings menu, press the Navigation buttons: x 3, To exit the dishwasher's Settings menu, select Exit and confirm your selection with Start/Stop. Navigation buttons for choosing setting Confirm current setting... - Page 13 Settings Options If the dishes have water marks. Decrease the rinse aid dosage: If the dishes have a sticky white/blue film. If the dishes are streaked. Build-up of foam. If you have very soft water, the rinse aid can be diluted 50:50 with water. When using an all-in-one detergent that contains rinse aid, you can activate the setting TAB.
-
Page 14: Care And Cleaning
Care and cleaning Fine filter Top up rinse aid Debris that collects on the fine filter is automatically rinsed away during When the rinse aid needs topping up, the above symbol lights on the each wash. Clean the fine filter when necessary. display. - Page 15 3. Scoop out the water from the dishwasher tub. 4. In order to inspect the drainage pump, remove the coloured stop on the right in the bottom drain. 5. Turn the pump wheel located behind the drainage pump stop by hand.
-
Page 16: Troubleshooting
Troubleshooting Type of fault on the display Action Overfilling water 1 Clear the drainage pump. See the chapter Care and cleaning. If the problem persists, call the service department. Water outlet fault See “Water remains in the dishwasher” in the table “Problem” below. If the problem persists, call the service department. - Page 17 Problem Possible causes Action The dishes are not clean. The spray arms do not rotate. Check that the dishes are not blocking the spray arms. Spray arm holes or bearings blocked. Clean the spray arms. See Chapter Care and cleaning. Unsuitable dishwashing program.
- Page 18 Problem Possible causes Action Water remains in the dishwasher. The filters are blocked. Clean the coarse and fine filters. The filters are not fitted correctly. Check that the filter handle is locked in the stop position. The handle should point towards the back of the dishwasher.
-
Page 19: Technical Information
Technical information Information on energy labelling Energy labelling Australian standard: AS/NZS 2007 Number of place settings: Dishwashing programs: ECO wash Program time: 1:58 hours:minutes Connection: Cold water 20 °C Test method for noise measurement: IEC 60704-2-3 This dishwashing program is the standard cleaning cycle used to compile the energy labelling information. It is intended for washing normally dirty dishes and is the most effective program in terms of combined energy and water consumption. -
Page 20: Installation
Installation [mm] 1198 30-94 *Remove locking nuts for an installed height of 820-821 mm. Nominal dimensions. Actual measurements may vary. Safety instructions Transport protection for the door Connections to electricity, water and drainage must be performed Do not forget to remove the transport protection for the door when by a qualified professional. - Page 21 If the dishwasher is built-in the surrounding cabinetry must be resistant Adjust the height and slide the to any condensation from the dishwasher. dishwasher into place B. Freestanding 1. Start by measuring the height from the floor to the bottom edge of A freestanding dishwasher must be fitted with anti-tip brackets.
- Page 22 Connection to hot water supply Drainage connection Connect the dishwasher to the hot water supply (max. 70 °C) if the This dishwasher is suitable for installing in a raised recess (to attain building is heated using an energy-efficient means such as district an ergonomic working height).
- Page 23 Screwing the dishwasher into place Dishwasher kick panel (Applicable only to built-in dishwashers.) The dishwasher is supplied with a kick panel. After fastening the machine, check that the front feet still touch the Install the sound insulation floor. (only certain models) Screw the dishwasher into place with two extra screws If there is an air gap of more than 3 mm between the underside of the worktop and the top of the dishwasher, the dishwasher should be...
-
Page 24: Asko Service
Read the chapter Troubleshooting before contacting the service department. If you have encountered a problem that you cannot resolve, please contact your nearest dealer, see www.asko.com. When making contact, provide the details on the serial number plate. Include the article number (1) and the serial number (2). -
Page 25: Your Notes
Your notes... - Page 26 Your notes...
- Page 27 Your notes...
-
Page 28: Quick Guide
Replenish salt and rinse aid to achieve good washing and drying results. (See page 4.) Top up rinse aid Top up salt Select a program (See page 9.) Press Start/Stop, close the door START STOP ASKO APPLIANCES SOCKERBRUKSGATAN 3, SE-531 40 LIDKÖPING, SWEDEN WWW.ASKO.COM...