Kohler 14RES Manual page 99

8. Install the exhaust system. See Figure 6-27.
a. Install the heat shield onto the alternator
exhaust support.
b. Using new gaskets, connect the engine
exhaust muffler to the engine at the flanges. Do
not final tighten the mounting hardware.
c. Secure the muffler mounting tab to the heat
shield.
d. Torque the nuts securing the engine muffler
flange to the engine to 24 Nm (17.7 ft. lb.).
1
1. Exhaust flanges (qty. 2)
2. Muffler
3. Alternator vibromounts (qty. 2)
4. Engine vibromounts (qty. 2)
Figure 6-27 Exhaust System
TP-6735 7/17
2
4
TP-6735
3
9. Reinstall the alternator and exhaust duct panels
shown in Figure 6-28.
2
1
1. Alternator duct
2. Exhaust duct panels
Figure 6-28 Alternator and Exhaust Ducts
10. Reconnect the following alternator wiring inside
the controller junction box.
diagrams in Section 7.
a. Reconnect lead 55 to the mini-breaker on the
controller.
b. Reconnect P2 to the controller.
c. Reconnect leads 2 and 3 to neutral stud L0.
d. Reconnect leads 1 and 4 to the circuit breaker.
e. Reconnect any other controller connections
that were removed during disassembly.
11. Press the OFF button on the generator set
controller.
12. Reconnect the generator set engine starting
battery, negative (--) lead last.
13. Reinstall fuse F3.
14. Reconnect the carburetor heater (if equipped) to
the 120VAC receptacle.
15. Reconnect the battery charger to the 120VAC
receptacle.
16. Reconnect output leads or load circuit cables at the
field-connection terminal block.
Section 6 Disassembly/Reassembly
2
2
TP-6735
See the wiring
99