Ferris SNAPPER PRO FAST-Vac 61 Operator's Manual page 29

IS2000Z Series
1. Install the weight carrier (A, Figure 44) onto the
front of the unit and secure with the 3/8-16 x
1-1/4" bolts (B), 3/8" washers (C) and 3/8-16"
nylock flange nuts (G).
NOTE: Use top holes in the weight carrier for the
IS2000Z Series (as shown in Figure 44).
2. Install the counter weights (D) in the weight carrier
and secure with the retaining pin (E) and hairpin
clips (F).
IS4500Z Series
1. Support the front of the frame in the center of the
unit with a jackstand.
2. Remove the 1/2-13 x 5" bolts (B, Figure 45) and
1/2-13 nylon lock nuts (C) securing the front
suspension arms to the frame.
3. Install the weight carrier (A) onto the front of the
unit and secure with the 1/2-13 x 5" bolts and 1/2-
13 nylon lock nuts previously removed.
4. Install the counter weights (D) in the weight carrier
and secure with the retaining pin (E) and hairpin
clips (F).
A
C
B
D
E
F
Figure 44. Install Weight Carrier
A. Weight Carrier
B. 3/8-16X1-1/4" Bolt
C. 3/8" SAE Washer
D. Weight
E. Retaining Pin
F. Hairpin Clip
G. 3/8-16 Nylock Flange Nut
A
C
D
E
Figure 45. Install Weight Carrier
A. Weight Carrier
B. 1/2-13 x 5" Bolt
C. 1/2-13 Nylon Lock Nut
D. Weight
E. Retaining Pin
F. Hairpin Clip
Installation
G
B
F
27
GB