Ferris SNAPPER PRO FAST-Vac 61 Operator's Manual page 21

IS3100Z with 4-Tube Rear Bumper
1. If the engine is hot, allow sufficient time for the
muffler to cool to prevent a burn injury during
installation.
2. Remove the rear engine shield (C, Figure 29) from
the top of the rear bumper (D) by removing the
3/8" hardware (A, B, & E) securing the shield to
the bumper.
3. Install the collector mount plate (A, Figure 30) on
to the bumper. Install two of the 3/8-16 U-bolts
(C) over the top bumper tube and through the
mounting plate and loosely secure with the 3/8-16
nylock flange nuts (B).
4. Install the remaining 3/8-16 U-bolt bolt (C) over
the third tube down from the top of the bumper
and loosely secure with the 3/8-16 nylock flange
nuts (B).
5. Center mount plate on the bumper and tighten all
the hardware securely.
IS3100Z Series with 5-Tube Rear Bumper
1. Install the collector mount plate (A, Figure 31) on
to the bumper. Install two of the 3/8-16 U-bolts
(C) over the second tube down from the top of
the bumper and through the mounting plate and
loosely secure with the 3/8-16 nylock flange nuts
(B).
2. Install the remaining 3/8-16 U-bolt bolt (C) over
the forth tube down from the top of the bumper
and loosely secure with the 3/8-16 nylock flange
nuts (B).
3. Center mount plate on the bumper and tighten all
the hardware securely.
A
B
C
D
Figure 29. Remove the Rear Engine Shield
A. 3/8-16X1" Bolts
B. 3/8" Washers
C. Rear Engine Shield
D. Rear Bumper
E. 3/8" Nylon Flange Nuts
A
B
Figure 30. Install Collector Mount Plate
A. Mount Plate
B. 3/8-16 Nylock Flange Nuts
C. 3/8-16 U-Bolts
A
B
Figure 31. Install Collector Mount Plate
A. Mount Plate
B. 3/8-16 Nylock Flange Nuts
C. 3/8-16 U-Bolts
Installation
E
C
C
19