Table of Contents
Advertisement
Collector Installation
IS3000Z Series
1. Install the collector mount plate (A, Figure 32) and
mount tabs (B) on to the bumper. Install the 3/8-
16 x 2-3/4" bolts (C) through the mount tabs and
loosely secure with the clamp bars (D) and 3/8-16
nylock flange nuts (F).
2. Install the 3/8-16 x 2-1/2" bolts (E) through the
bottom mounting holes and loosely secure with
the clamp bars (D) and 3/8-16 nylock flange nuts
(E).
3. Center mount plate on the bumper and tighten all
the hardware securely.
4. Temporarily install the collector mount posts (A,
Figure 33) into the collector plate and install the
hitch pins (B). This will insure that the holes are
properly aligned for easy installation and removal.
5. Tighten the top mounting bolts (C, Figure 32)
securely and remove the hitch pins and mount
posts.
20
A
B
C
E
C
E
Figure 32. Install Collector Mount Plate
A. Mount Plate
B. Mount Tab
C. 3/8-16 x 2-3/4" Bolt
D. Clamp Bar
E. 3/8-16 x 2-1/2" Bolt
F. 3/8-16 Nylock Flange Nut
A
B
Figure 33. Install Mount Posts & Hitch Pins
A. Mount Post
B. Hitch Pin
www.ferrismowers.com | www.snapperpro.com
D
F
D
B
Advertisement
Table of Contents
