Table of Contents
Advertisement
Installation
COLLECTOR INSTALLATION
Install the Collector Mount Plate
Identify and follow the correct procedure for your unit.
IS2000Z Series, & IS4500Z Series
IMPORTANT NOTE: If the collector system is being
installed on an IS4500Z Series model, the Extreme
Duty Rear Bumper Kit (part #5600019) must be
installed first. The Extreme Duty Rear Bumper Kit
(part #5600019) is included with Bagger Kit 5600009.
1. Install the collector mount plate (A, Figure 27) and
mount tabs (B) on to the bumper. Install two of
the 3/8-16 U-bolts (C) over the top bumper tube
and through the mount tabs and loosely secure
with the 3/8-16 nylock flange nuts (F).
NOTE: On IS500Z models use the inner mounting
holes when installing the collector mount plate and
mount tabs to the bumper with the 3/8-16 U-bolts
2. Install the remaining 3/8-16 U-bolt bolt (C) over
the middle bumper tube and loosely secure with
the 3/8-16 nylock flange nuts (E).
3. Center mount plate on the bumper and tighten all
the hardware securely.
4. Temporarily install the collector mount posts (A,
Figure 28) into the collector plate and install the
hitch pins (B). This will insure that the holes are
properly aligned for easy installation and removal.
5. Tighten the top nuts (C) securely and remove the
hitch pins and mount posts.
18
A
B
D
D
D
B
Figure 27. Install Collector Mount Plate
A. Mount Plate
B. Mount Tab
C. 3/8-16 U-Bolts
D. 3/8-16 Nylock Flange Nuts
A
B
Figure 28. Install Mount Posts & Hitch Pins
A. Mount Post
B. Hitch Pin
C. 3/8-16 Nylock Flange Nuts
www.ferrismowers.com | www.snapperpro.com
C
C
Advertisement
Table of Contents
