Alcatel-Lucent Cloud Edition
DeskPhone
External ringing interface module (MWS 3GV28050AA)
The accessory is supported by the following sets
You have to use a RJ11 to SATA adapter to connect your deskphone to this device. The RJ11 to SATA adaptator is
sold separately (3MG07058AA).
The external ringing interface module allows driving an external system (like a ring or a lamp), following the ring
tone cadence of the phone set connected on the telephone line. A switch on the electronic board allows selecting
between 2 operation modes.
•
Follows the cadence: the relay follows exactly the ring signal.
•
Hold mode: the relay is held for 0,7 s after the ring signal is gone. It erases some of the ring
pulses.
8.4.1 List of supplies
•
1 external ringing interface module.
•
3 circuits plug to screw.
•
1 RJ11/RJ11 3 meters (10 feet) cable.
•
1 DC Japan/DC Japan 3 meters (10 feet) power cable.
A power supply may be required to power the module when used with IP phone powered remotely (Power Over
Ethernet).
Use only the following power supply (Sold separately):
•
3AK27097 (commercial part number).
•
1AF00446 (technical part number).
8.4.2 Installation
WARNING: The module must be closed before use. No settings require the module to be open.
In idle state:
8AL90362ENRB ed01
8068s CE
8058s CE
The phone is ringing:
8018 CE
8008/8008G CE
N: common.
NC: active signal.
NO: non-active signal.
71 /86