Blocks And Errors - Rinnai E110CN Installation & Servicing Instructions Manual

15

Blocks and Errors

Error indication (short reference)
Blocks with a number in the last 2 positions.
Block 01:
Block 11:
ring the block normal operation of the hot water supply is possible. The pump continues to operate
at minimum capacity during the block.
Block 12:
During the block normal operation of the central heating installation is possible. During the block the
pump continues to operate at minimum capacity.
Block 60:
Block 67:
After the T has disappeared the block will clear.
Block 85:
flow is detected, the venting cycle is ended and the burner is released.
Error with a number in the last two positions.
Error 00:
Error 01:
Error 02:
Error 04:
Error 05:
Error 12:
Error 18:
Error 19:
Error 28:
Error 69:
68
A detected error is indicated on the display by means of blocking or error messages.
A distinction should be made between these two messages due to the fact that bloc-
king can be of a temporary nature, however, error messages are fixed lockings. The
control will try its utmost to prevent locking and will temporarily switch off the unit by
blocking it. Hereunder is a list of some messages.
External safety contact cut off
Maximum T of flow and return sensor in central heating has repeatedly been exceeded. Du-
Maximum T of flow and return sensor in domestic hot water has repeatedly been exceeded.
Incorrect parameter setting of the minimum or maximum power.
A T has been detected between flow and return sensor whereas the burner is not in operation.
The control has not detected a water flow. The venting cycle is started. If during this cycle water
Poor flame-forming
short-circuit of 24 volt circuit
no flame-forming
adjustment or error for voltage interruption
adjustment
fuse 24 volt/3AT faulty
maximum flow temperature exceeded
maximum return temperature exceeded
number of revolutions not reported back from fan
no or incorrect display