Panasonic KX-FP342CX Service Manual page 123

6.6.6.1. JOURNAL 2
Refer to JOURNAL 2 in
Journal 2 displays the additional detailed information about the last 35 communications.
Descriptions:
(1) RCV. MODE
Indicates which receive mode the unit was in when the unit received a fax message.
This information is also displayed when the unit transmitted a fax message.
(2) SPEED
Indicates the speed of the communication. If multiple pages are transmitted or received, it
indicates the last page's communication speed. If there is a communication error, "?" is
displayed.
(3) RESOLUTION
Indicates the resolution of the communication. If multiple pages are transmitted or received, it
indicates the last page's resolution. If there is a communication error, "?" is displayed.
(4) RCV-TRIG. (CNT.)
Indicates the trigger that causes the unit to switch to the fax receive mode. The available options
are listed in JOURNAL 2 in
times the trigger has been used. (For example, "0003" means three times.)
No. Display
1 FAX MODE
2 MAN RCV
3 FRN RCV
4 VOX
5 RMT DTMF
6 PAL DTMF
7 TURN-ON
8 TIME OUT
9 IDENT
10 CNG OGM
11 CNG ICM
(5) ERROR MEMORY
Indicates the reason why the unit received a fax message in memory.
If you look at No.11 in the JOURNAL 2 in
received in memory due to "PAPER OUT" error.
[NO RESPONSE DISAPPEARED ON JOURNAL]
The "NO RESPONSE DISAPPEARED ON JOURNAL" displays the information about the last 10
PRINTOUT EXAMPLE().
PRINTOUT EXAMPLE(). The values in parenthesesindicate how many
Means the unit received a fax message in the FAX mode.
Means the unit received a fax message by manual operation.
Means the unit received a fax message by friendly signal detection.
Means the unit detected silence or no voice.
Means the unit detected DTMF (Remote Fax activation code) entered
remotely.
Means the unit detected DTMF (Remote Fax activation code) entered by a
parallel connected telephone.
Means the unit started to receive after 10 rings. (Remote Turn On: Service
Code #573)
Means the unit started to receive after Ring Time Out in the EXT-TAM or TEL
/FAX mode.
Means the unit detected Ring Detection.
Means the unit detected the CNG while it was sending the Dummy Ring
Back Tone in the TEL/FAX mode.
OR
Means the unit detected the CNG while it was sending the OGM in the ANS/
FAXmode.
Means the unit detected the CNG while it was recording the ICM in the ANS/
FAX mode.
PRINTOUT
Function
EXAMPLE(), it shows the fax message was
123