Panasonic KX-FP342CX Service Manual page 112

Compact plain paper fax woth copier
Table of Contents

Advertisement

(1)
(2) RESULT
CODE
PRESSED THE STOP KEY
DOCUMENT JAMMED
NO DOCUMENT
40
OTHER FAX NOT
RESPONDING
41
COMMUNICATION ERROR
42
COMMUNICATION ERROR
43
COMMUNICATION ERROR
44
COMMUNICATION ERROR
46
COMMUNICATION ERROR
48
COMMUNICATION ERROR
49
COMMUNICATION ERROR
50
COMMUNICATION ERROR
51
COMMUNICATION ERROR
52
OTHER FAX NOT
RESPONDING
54
ERROR-NOT YOUR UNIT
58
COMMUNICATION ERROR
59
ERROR-NOT YOUR UNIT
64
COMMUNICATION ERROR POL.RX Polling is not possible.
65
COMMUNICATION ERROR
65
COMMUNICATION ERROR
68
COMMUNICATION ERROR
70
ERROR-NOT YOUR UNIT
72
COMMUNICATION ERROR
74
JUNK FAX PROH.
REJECT
75
MEMORY FULL
79
CANCELED
FF
COMMUNICATION ERROR
SND=TRANSMISSION RCV=RECEPTION
Most fax communication problems can be resolved by the following steps.
1. Change the transmit level. (Service code: 596, refer to
FUNCTION
TABLE().)
2. Change the TX speed/RX speed. (Service code: 717/718, refer to
(3) MODE
SND &
Communication was interrupted by the STOP
RCV
button.
SND
The document paper is jammed.
SND
No document paper.
SND
Transmission is finished when the T1 TIMER
expires.
SND
DCN is received after DCS transmission.
SND
FTT is received after transmission of a 2400BSP
training signal.
SND
No response after post message is transmitted
three times.
SND
RTN and PIN are received.
RCV
No response after FTT is transmitted.
RCV
No post message.
RCV
RTN is transmitted.
RCV
PIN is transmitted (to PRI-Q).
RCV
PIN is transmitted.
RCV
Reception is finished when the T1 TIMER expires.
RCV
DCN is received after DIS transmission.
RCV
DCN is received after FTT transmission.
SND
DCN responds to the post message.
SND
DCN is received before DIS reception.
RCV
Reception is not EOP, EOM PIP, PIN, RTP or RTN.
RCV
No response at the other party after MCF or CFR is
transmitted.
RCV
DCN is received after CFR transmission.
RCV
Carrier is cut when the image signal is received.
RCV
The junk fax prohibitor of your unit rejected fax
reception.
RCV
The document was not received due to memory full.
SND
The multi-station transmission was rejected by the
user.
SND &
Modem error. For the DCN, DCN, etc. abbreviations,
RCV
refer to
MODEM SECTION
112
SYMPTOM
().
SERVICE

Advertisement

Table of Contents
loading

Table of Contents