Tape Tangled along Tape Path
1. Carefully pull out excess tape and untangle.
2. Set the drive on its left side with the head and tape path facing up.
Figure E-10. Rewinding tape into cartridge
3. Turn the supply reel ( 4 in Figure E-10) clockwise.
4. Continue spooling into the cartridge until the tape is taut and remains within the
5. Reassemble the chassis by following the steps in "Removing a Drive from an
6. Allow the drive to perform mid-tape recovery. This takes several minutes. When
Note: If you find the tape to be broken, go to one of the following appropriate
procedures:
v "Tape Spooled off Supply Reel" on page E-7
v "Tape Pulled from or Broken near Leader Pin" on page E-8
--OR--
"Tape Broken in Mid-tape" on page E-9
1
1
Loader motor worm gear
2
Outer guide rail
WARNING: DO NOT
TOUCH
flanges of the tape guiding rollers. turn the supply reel ( 4 in Figure E-10) 10
turns. Ensure that you do not stretch the tape.
Enclosure" on page E-1.
this activity completes, push the Unload button to eject the cartridge.
2
4
3
Takeup reel motor
4
Supply reel motor
Appendix E. Information for Trained Service Personnel
3
E-11