4
Figure E-3. Removing the screws securing the internal drive
3. Loosen the 4 screws securing the internal drive to the chassis.
4. Place your hand underneath the internal drive to support it.
5. Remove the 4 screws ( 4 in Figure E-3) securing the internal drive to the
6. While still supporting the internal drive and chassis with your hand, turn the
7. Slide the internal drive back towards the rear of the chassis to clear the front
Figure E-4. Lifting the internal drive from the chassis
E-4
TS2240 Tape Drive Setup, Operator and Service Manual
chassis.
chassis over on to its feet.
Note: The internal drive is loose from the chassis so hold the internal drive and
chassis securely.
bezel and then lift the internal drive out of the chassis.
4