Function Code L: Load/Unload Test - IBM System Storage TS2240 Tape Drive Setup, Operator, And Service Manual

but the execution time is significantly longer than the "Approximate Run Time", run
"Function Code F: Write Performance Test" on page 3-17. If the Write Performance
Test fails, replace the media and exit maintenance mode.
Press the Unload Button to stop the diagnostic and exit maintenance mode.
Pressing the Unload Button once will abort the test at the end of the current test
loop. Pressing the Unload Button twice will abort the test immediately. Wait for the
drive to rewind the tape and unload the cartridge.
Attention:
that may be overwritten. During the test, the drive overwrites the data on the
cartridge.
Note: If you inserted an invalid tape cartridge (e.g. Gen1 or WORM media), error
1. Place the drive in Maintenance Mode. For instructions, see "Entering
2. Press the Unload Button once per second until
3. Press and hold the Unload Button for three or more seconds, then release it to
4. Insert a scratch (blank) data cartridge. The SCD changes to a flashing

Function Code L: Load/Unload Test

Approximate Run Time = 15 seconds per loop
Total Number of Loops = 10
Function Code
Press the Unload Button to stop the diagnostic and exit maintenance mode.
Pressing the Unload Button once will abort the test at the end of the current test
loop. Pressing the Unload Button twice will abort the test immediately. Wait for the
drive to rewind the tape and unload the cartridge.
3-20
TS2240 Tape Drive Setup, Operator and Service Manual
For this test, insert only a scratch (blank) data cartridge or a cartridge
7
code appears in the SCD. If you inserted a write-protected cartridge, or
the media has read-only compatibility (e.g., Gen2 media), error code
appears in the SCD. In either case, the tape drive unloads the cartridge and
exits Maintenance Mode after the cartridge is removed.
Maintenance Mode" on page 3-9.
cycle past the desired code, press the Unload Button once per second until the
code reappears.)
select the function. The SCD changes to a flashing
the tape drive runs the tests.
v If no error is detected, the diagnostic will loop and begin again. To stop the
loop, press the Unload Button for one second and release. When the loop
0
ends, temporarily appears in the SCD.
v If an error is detected, the Status Light flashes amber and the drive posts an
error code to the SCD. To determine the error, locate the code in Appendix A,
"Error Codes and Messages," on page A-1. To clear the error either turn the
power off and then on again, or reboot the drive by pressing and holding the
Unload Button for 10 seconds.
L
tests the drive's ability to load and unload a tape cartridge.
J
appears in the SCD. (If you
C
.
P
J
and