Function Code U: Post Error Reporting Disabled - IBM System Storage TS2240 Tape Drive Setup, Operator, And Service Manual

Function Code U: Post Error Reporting Disabled

When Post Error Reporting is disabled, deferred-check conditions are not reported
to the host and temporary errors are not reported in the sense data. This is the
normal (default) setting for the drive. When the drive has Post Error Reporting
disabled, Function Code
default to Post Error Reporting disabled after a reboot or power off/on cycle.
1. Place the drive in Maintenance Mode. For instructions, see "Entering
2. Press the Unload Button once per second until either
3. Exit Maintenance Mode if you do not want to change the current setting for Post
4. To disable Post Error Reporting, Press and hold the Unload Button for three
5. Press the Unload Button once per second to select another Maintenance Mode
3-22
TS2240 Tape Drive Setup, Operator and Service Manual
U
Maintenance Mode" on page 3-9.
P U
SCD. or will appear in the SCD to indicate the current setting for Post
Error Reporting. If you cycle past the desired code, press the Unload Button
once per second until the code reappears.
Error Reporting. For instructions, see "Exiting Maintenance Mode" on page 3-9.
P
seconds while appears in the SCD. The SCD changes to
release the Unload Button.
Function. To exit Maintenance Mode, refer to "Exiting Maintenance Mode" on
page 3-9.
will be displayed in Maintenance Mode. The drive will
P U
or appears in the
U
after you