How To Install And Pair A Suunto Tank Pod - Suunto EON User Manual

Suunto EON Steel Black
1. Keep the middle button pressed to enter menu.
2. Browse to General » Device settings » Time & date.
3. Scroll to Set time or Set date with the upper or lower button.
4. Press the middle button to enter the setting.
5. Adjust the setting with the upper or lower button.
6. Press the middle button to move to the next setting.
7. Press again the middle button when last value is set to save and go back to Time & date
menu.
8. Keep middle button pressed to exit when done.
To change time and date formats
1. Keep the middle button pressed to enter menu.
2. Browse to General » Device settings » Units & formats.
3. Scroll to Time format or Date format with the upper or lower button.
4. Follow steps 5-8 as above to change and save formats.

5.5. How to install and pair a Suunto Tank POD

To install and pair a Suunto Tank POD:
1. Install the Tank POD as described in the Tank POD quick guide or in the Tank POD user
guide.
2. After installing the Tank POD and opening the valve, wait for the green LED on the Tank
POD to flash.
3. If your Suunto EON Steel Black has a blank screen, press any key to activate it.
4. Use proximity pairing: Hold your Suunto EON Steel Black close to the Tank POD. Make
sure you follow the instructions in Tank POD alignment section of the Tank POD user
guide.
5. After a few seconds, a menu pops up on the screen showing the Tank POD serial number,
battery status and the tank pressure. Select the correct gas from the list to pair with your
device and press the middle button to confirm pairing.
NOTE: The battery level indication shown when pairing the Tank POD is an
approximation only.
6. Repeat the procedure above for additional Tank PODs and select different gases for each
POD.
Alternatively, you can pair the Suunto Tank POD(s) from the menu:
1. In the Gases menu, select the gas you want your Tank POD to pair with.
49