Table of Contents
Advertisement
Suunto EON Steel Black
Yellow indicates ascent rate is moderately high, 8-10 m (26-33 ft) per minute
•
Red indicates ascent rate is too high, over 10 m (33 ft) per minute
•
When maximum allowed ascent rate is exceeded for five seconds, an alarm is generated.
Ascent rate violations result in longer safety stop times and mandatory safety stops.
WARNING: DO NOT EXCEED THE MAXIMUM ASCENT RATE! Rapid ascents increase the
risk of injury. You should always make the mandatory and recommended safety stops after
you have exceeded the maximum recommended ascent rate. If this mandatory safety stop is
not completed the decompression model will penalize your next dive(s).
4.4. Battery
Suunto EON Steel Black has a rechargeable lithium-ion battery. Charge the battery by
connecting Suunto EON Steel Black to a power source with the included USB cable. As a
power source use either your computer USB port or a wall charger.
The battery icon in the upper left corner of the display shows the battery status. To the right of
the battery icon is the estimated remaining dive time in hours.
Icon
A pop-up message indicates when recharge is needed.
4.5. Bookmark
Adding a bookmark (timestamp) to an active log is really easy in Suunto EON Steel Black. See
5.9. How to add bookmarks for the procedure.
16
Explanation
Estimated remaining dive time is 27 hours; no immediate need to recharge
Estimated remaining dive time is three (3) hours or less; recharge needed
Estimated remaining dive time is less than one (1) hour; recharge
immediately.
When the charge level drops below two (2) hours, you cannot start a dive
with Suunto EON Steel Black.
Battery is charging, showing current charge level as remaining dive time
Advertisement
Table of Contents
