Touchpad - HP 240 14 inch G9 Maintenance And Service Manual

3. Lift the board (4), and then slide it outward from under the clips that hold it on place to remove it (5).
TIP:
prevent damage to the board or clips.
Reverse this procedure to install the touchpad click board.

Touchpad

To remove the touchpad, use this procedure and illustration.
Table 5-11 TouchPad description and part number
Description
Touchpad
Before removing the touchpad, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the rubber feet (see
3. Remove the bottom cover (see
4. Remove the battery (see
5. Remove the touchpad click board (see
To remove the touchpad click board:
1. Peel the conductive tape off the keyboard (1).
44 Chapter 5 Removal and replacement procedures for authorized service provider parts
The edge of the board sits under clips. Be sure to slide the board out from under the clips to
Computer feet on page
Bottom cover on page
Battery on page
Preparation for disassembly on page
32).
33).
35).
Touchpad click board on page
Spare part number
L24484-001
32).
43).