Device Pairing
Select Device Pairing to configure settings for pairing the touch screen to a CEN-ODT-C-POE.
The CEN-ODT-C-POE provides local occupancy reporting for supported room scheduling apps.
NOTE: For more information on the occupancy sensor, refer to the
Supplemental
Guide. For more information on configuring the occupancy source in the
Crestron scheduling application, refer to the
Guide.
Settings Tab – Device Pairing
Device Model: Use the drop-down menu to select POE Occ Sensor.
l
Pairing Retry Time (Min): Enter a duration (in minutes) that must elapse before the CEN-
l
ODT-C-POE reattempts to pair to the touch screen.
Pairing Status: Reports whether the CEN-ODT-C-POE is paired to the touch screen
l
(Online) or not (Offline).
Device IP Address/FQDN: Enter the IP address or fully qualified domain name of the CEN-
ODT-C-POE. This is required for device pairing.
Device Authentication: Enter authentication credentials for the CEN-ODT-C-POE (if
required):
Device Username: Enter a valid username used to access the device.
o
Device Password: Enter a valid password used to access the device.
o
136 • TS-70 Series
Crestron Room Scheduling Panels Operations
CEN-ODT-C-POE
Product Manual — Doc. 8555F