Table of Contents
Advertisement
Installation
General
Before starting the installation, a backup of the installation parameters of the
MAMMOMAT has to be carried out.
1.
2.
3.
4.
Sub-assemblies, overview
The components shall be placed according to the figure below.
Biopsy
controller
Stand with
X-ray unit
Fig. 1
MAMMOMAT 3000 Nova with digital biopsy and spot imaging system Opdima
NOTE
Siemens-Elema AB
Solna, Sweden
Connect a PC to the MAMMOMAT and start the service program.
Select Main menu => Backup => Copy installation area to disk => All.
This will store the installation parameters on the hard disk of the PC.
Select Main menu => Backup => Copy installation area to floppy => All.
This will store the installation parameters on the service diskette.
Switch off the MAMMOMAT.
X
X
Y
Y
Z
Z
X
Z
Y
Workstation table
The workstation shall be placed at least 1.5 m from the object
table of the stand.
Register 3
Biopsy unit
CCD camera
SPB7-230.033.10
Rev. 03
08.02
5
Generator
Workstation
?
Page 1 of 26
SPS-UD
5 - 1
5
5
Opdima?
Installation
Advertisement
Table of Contents
