Technical Features - Jacuzzi experience Virginia Instructions For Preinstallation

It is the responsibility of the installer/owner to ascer-
tain compliance with specific local regulations prior to
installation.
Jacuzzi Europe S.p.A. gives no guarantee in this respect
and refuses all responsibility regarding compliance of
the installation carried out.

Technical Features

i
Virginia Experience ( 1) includes:
- a control unit, called "Spa-Pak"
- the compensation tank (
required to hold water that overflows when users get into the
tub. Its nominal capacity is 1,000 litres (operating with about
800-850 litres).
i
- the Minipool ( 1, C), is to be connected, with hoses, to the
"Spa-Pak", the compensation tank and the drain.
MAXIMUM ABSORPTION FOR THE SYSTEM
• version without blower
Power supply Total consumption electric hea-
(three-phase) ter + pumps + spotlights
Voltage Hertz Ampere
(*)
220 - 240 3~
50
380 - 415 3N~ 50
(*): special standard (does not apply to Europe)
• version with blower
Power supply Total consumption electrical heater
(three-phase) + pumps + spotlights + blower
Voltage Hertz Ampere
(*)
220 - 240 3~
50
380 - 415 3N~ 50
(*): special standard (does not apply to Europe)
WEIGHTS
MINIPOOL
Net weight average fill
kg
litres
~ 1700
~250
area involved resting surface
m 2
m 2
~1,13
~5,63
Max. weight
when full
kg
COMPENSATION
~925
TANK
~285
SPA-PAK
Heat exchanger (optional)
- MAX primary circuit temperature ..............................................................50 °C
- Connections.....................................................................................................................3/4"
- Primary circuit flow rate...............................................................................38 l/min
- Primary pressure drop ......................................................................0,271 m H 2 O
i
( 1, A) .
i
1, B) which, once connected, is
Total consumption only pumps and
spotlights (version with exchanger)
kW Ampere
(j)
44 16,5 12
(j)
16,5
25 7
(j): Max. absorbed power
Total consumption only pumps, blower
and spotlights (version with exchanger)
kW Ampere
(j)
17
45 13
(j)
26 17 8
(j): Max. absorbed power
maximum
water volume max. weight
litres
~ 2100
average load on area concentrated load on
involved resting surface
kg/m 2
~ 418 ~ 2080
resting surface
at floor level at floor level
m 2
~1,2
~1,1
Components
Components and the necessary connections for setting up the sys-
tem are described below (see
Minipool and hosing
1 overflow channel with grid
2 pneumatic buttons
2a box for connection of pneumatic buttons
3 low-point drain with gate valve
4A1+4B1 to the compensation tank (overflow lines)
to the compensation tank (overflow lines)
4A2+4B2
from the overflow channel (overflow lines)
4C1/4C2
5 hydromassage pump suction lines
6 hydromassage pump delivery lines
7 filtering suction line
8 suction line from the compensation tank
9 filtering return line
10 blower line
11 connections to the water system
12 perimeter metal supports
Spa-pak
13 Electric wiring box
14 optional - 14b: heater or 14a: heat exchanger
kW 15 hydromassage pumps
(j)
4,5
16 filtering pump
(j)
4,5
17 blower
18 quartz sand filter
19 safety switch
20 temperature sensor
21 flow switch (models with heater)
kW
Compensation tank
(j)
5
22 water loading/filling solenoid valve (3/4")
(j)
5
23 level switches
24 check valve
25 gate valve (for emptying)
26 pre-filters
27 overflow
Total
28, 29 ground drainage points
kg
30 gate valves (for system maintenance)
~ 2350
31 gate valves (for suction balancing)
32 hose draining (areas at risk from ice)
kg/m 2
Water connections
I
The hosing system (including connectors, gate valves, etc.,
load
2) for connecting the Minipool to the Spa-Pak and the compensa-
kg/m 2
tion tank, must be set up by the installer.
~770
~260 I
The Customer must provide the ground drainage points (
detail 27 and 28) of suitable dimensions, which can be inspected
for any cleaning, and to which the low-point drain ø 50 mm (
detail 3), the loading/overflow of the compensation tank and the
drain from the filter are to be connected.
CAUTION! Before preparing the ground drainage
points, consult the local authority for the regula-
13
i
2).
i
i
2,
i
2,