Siemens SICHARGE CC AC22-ERK Operating Manual page 17

Operation
4.3 Charging process
Start charging with RFID or app
Proceed as follows to start charging:
1. Check if the required charging point is ready for operation: The status LED must light up
green.
2. Use the left or right pushbutton to select the desired charging point.
3. Authenticate yourself at the charging station.
Depending on the operator configuration (configuration via web interface or backend),
these methods are available:
– Hold RFID card in front of the card reader
– Open operator app and scan QR code
Figure 4-4 Authentication
4. Depending on the configuration (configuration via web interface or backend) of your device,
the software will now check your authorization to charge a vehicle.
5. The charging station now unlocks the cover lock.
6. Plug the plug connector of the charging cable into the power outlet of the charging station.
Make sure that the charging cable and the connecting cables are not damp or dirty. Follow
also the instructions of the vehicle manufacturer.
7. The communication connection to the vehicle is established. The LED status display changes
from yellow to blue. This process can take some time depending on the connection speed
and reaction speed of the backend.
16
1
SICHARGE Operating Manual ERK
Operating Manual, 02/2022, A5E48572458-AD