Table of Contents
Advertisement
NLRinse System
According to the manufacturer's
instructions, you can only use
dishwasher detergents with salt
substitutes up to a degree of
hardness of 21 °dH without adding
softening salt.
†The water hardness is 0 - 6
°dH. You do not need to use
softening salt.
Press.
1.
Approx. 3 seconds on
2.
to access the basic settings.
aThe display shows Hxx. aThe
display shows
to give.
Just as often on
3.
the display shows H00.
To save the settings, press . for
4.
about 3 seconds
aThe water softener has been
switched on and the refill
softener salt indicator is
deactivated.
Regenerate the softening
system
In order to maintain trouble-free
operation of the softening system, the
device regularly performs a
regeneration of the softening system.
The softening system is regenerated in
all programs before the end of the
main wash cycle. This increases the
running time and consumption values
of, for example, water and electricity.
26
Busy-
reflected
press until
to press.
Overview of the consumption values
when regenerating the
softening system
Here you will find an overview of the
maximum additional run time and
consumption values when regenerating
the softening system.
Regenerating the softening
system after x washes
Additional running time in minutes
More water consumption in litres
More power consumption in kWh
The stated consumption values are
laboratory measured values which
are determined according to the
currently valid standard and on the
basis of the Eco 50° program and the
factory-set water hardness value of 13
- 16 °dH.
Rinse System
rinse aid
For optimal drying results it is best
to use the rinse aid.
Only use rinse aid for household
dishwashers.
Filling rinse aid
If the rinse aid refill indicator lights up,
add rinse aid. Only use rinse aid for
household dishwashers.
6
7
5
0.05
Advertisement
Table of Contents
