3M Drive-Thru Basestation G5 Technical Bulletin page 7

3M™ Drive-Thru Systems
Install External Antenna(s)
If the store currently uses an External Antenna (either Omni-Directional or Patch Antenna), it is assumed that the
location of the external antenna is not going to change.
Follow the steps below to re-connect the existing external antenna.
a. Remove the external antenna cable from the XT-1 Basestation at the antenna connector.
b. Remove either the left or top antenna on the G5 Basestation.
IMPORTANT NOTE
DO NOT use a tool to tighten the pigtail to the Base Station; leave the connection finger tight.
c. Connect the external antenna cable removed from the XT-1 Basestation to the G5 Basestation antenna connec-
tor in the spot where the antenna was just removed.
Technical Bulletin #161 Release B
G5 Basestation Antenna
7