3M Drive-Thru Basestation G5 Technical Bulletin page 11

3M™ Drive-Thru Systems
IMPORTANT NOTE
The default Installer password is 12345 and the default User password is 1234.
Register Headset(s):
From the System Menu
- Select 04 Registration > 1 Add New Headsets.
- Power on the XT-1 headset when prompted. Insert the battery into the G5 headset to automatically power on
the headset.
- Wait up to two minutes for {Headset xxxxxxx Has Been Registered!} to appear at the bottom of the display.
- Repeat the steps above for additional headsets.
- Press Mode when finished.
Connect to G5 Basestation Web Server (For Configuration)
Please refer to 3M Technical Bulletin 160 - Setting up communication via 3M™ Drive-Thru Basestation G5 Web
Server.
Configuring G5 Basestation for Store Operation, Greeter, Alert and Reminder Functionality
All G5 Basestation configurations will have to be manually entered. Any configuration files you may have exported
from the XT-1 Basestation cannot be imported/loaded onto the G5 Basestation.
Please refer to the:
• Previously completed Pre-Installation checklist
G5 Basestation Model G5B1-Installation Manual
•
• G5 Basestation Model G5B1-Operating Instructions
In order to:
• Configure G5 Basestation for Store Operation
• Configure Greeter functionality on G5 Basestation
• Configuring Reminder messages on G5 Basestation
• Configuring Alert messages on G5 Basestation
Save the Current G5 Basestation Settings
In order to save the current G5 Basestation settings, you will have to:
• Enter the Configuration mode on the basestation and get to System Menu – See "Enter Configuration Mode" on
page 10.
• Select 14 Installer Setup.
• Change the value for Save Installation Settings to Yes.
Technical Bulletin #161 Release B
and to the
11