3M Drive-Thru Basestation G5 Technical Bulletin page 5

3M™ Drive-Thru Systems
Re-Wire Lane 1- Speaker, Microphone, Induction Loop to the G5 Basestation
Follow the illustration below to wire the Order Point Speaker, Microphone, Induction Loop, and Monitor Speaker (if
applicable).
IMPORTANT NOTE
If the current wires do not extend out to the terminals on the G5 Basestation, you may splice in sufficient length
of wire from an another spool of 3M Cable.
Make sure the point where you connect the two wires (or splice) is properly insulated with Electrical Insulation Tape
and/or securely held with wire nuts. This ensures against any accidental grounding of the wires.
Technical Bulletin #161 Release B 5