3M Drive-Thru Basestation G5 Technical Bulletin page 10

3M Graphics Warranties
3M™ Drive-Thru Systems
Power Up the G5 Basestation and Close the Basestation Cover
You may now power up the system by plugging in the Power Supply's barrel connector to the 12V input terminal on
the G5 Basestation, as illustrated:
To replace the basestation cover:
- Verify there are no obstructions (tools, etc.)
in the way of the cover being closed.
- Align the top edge of the cover with the
base.
- Swing the bottom half of the cover down
into place and gently push it against the
base until it locks into place.
- Tighten the two screws located at the
bottom of the cover.
Register (G5 and/or XT-1) Headsets to the G5 Basestation
In order to register headset(s) to the G5 Basestation, you will have to:
- Enter the Configuration mode on the Basestation
- Register headsets from the Registration option on the System Menu
Enter Configuration Mode
Configuration mode is a passcode-protected area that contains most of the configuration options for the G5
Basestation system. Using the access provided for users, it is possible to set up all of the functionality of the system.
To enter the configuration mode:
1. From the Run mode screen, enter your user passcode.
2. Press Mode. The display will show the user name and ID number
(e.g., Installer1ID = 1 or User1ID = 1)
3. Press Mode again and the system will display the Main Menu with options to select System Menu or Greeter
Menu.
4. Use keypad's arrow keys to navigate to System Menu and press Enter.
10 Technical Bulletin #161 Release B