Multiplexer Mode Mux - Panasonic WJ-SX 150A Operating Instructions Manual

• EXT IN
This stands for the setting of the EXT IN connector at the
unit's rear panel.
GEN LOCK ON: Select this mode to gen-lock the unit
with the recorder.
GEN LOCK OFF: Select this mode if the asynchronous
unit is connected to the recorder.
Notes:
• If GENLOCK ON is selected, the playback images can-
not be displayed on the monitors which are connected
to the connectors MONITOR OUT 1 to 4. Confirm the
images on those which are connected to the recorder.
• If GENLOCK OFF is selected, the maximum rate
recording becomes unavailable for WJ-HD500 Series.
• To use WJ-HD100 Series or a time-lapse VCR, the
Multiplexer board should be installed inside the unit.
• When the master-slave connection is applied, the Slave
tab will appear in the Recorder window. VCR/VTR will
be selectable besides other parameters.
98
Multiplexer Mode
How to Display
To display this window, click on the
Mode) button in the main window (p. 80.)
Parameters
• Multi Monitor Out Group
Still Display: Select the desired setting by clicking on
the drop-down menu.
ON: Still picture is available during the multiscreen
display.
OFF: Still picture is not available during the multi-
screen display.
The factory default setting is ON.
Border Color: Select the desired setting by clicking on
the drop-down menu. This setting will determine the
color of the border which separates each multi-
screen segment.
WHITE: The border will be displayed in white.
GRAY: The border will be displayed in gray.
BLACK: The border will be displayed in black.
OFF: No border will be displayed.
The factory default setting is WHITE.
Quad Shift: Select the desired setting by clicking on
the drop-down menu.
ON: Camera images are displayed in 4 multiscreen
segments (quad) and switched as follows:
4A = Page 1 of the quad (Camera 1, 2, 3 and 4)
4B = Page 2 of the quad (Camera 5, 6, 7 and 8)
4C = Page 3 of the quad (Camera 9, 10, 11 and
12)
4D = Page 4 of the quad (Camera 13, 14, 15
and 16)
OFF: Quad is unavailable.
The factory default setting is OFF.
MUX
(Multiplexer