Wj-Hd500 Series Control (Terminal Mode); Displaying Wj-Hd500 Series Setup Menu - Panasonic WJ-SX 150A Operating Instructions Manual

WJ-HD500 SERIES CONTROL (TERMINAL MODE)

Matrix switcher can control Digital Disk Recorder WJ-
HD500 Series. The following is the procedure of WJ-HD500
Series SETUP MENU.
Notes:
• The following operating procedures are for the terminal mode.
If you are using a PS·Data system controller, refer to p. 36.
• When a Multiplexer board is installed in the matrix switch-
er, you can neither connect nor control a WJ-HD500 Series
recorder. You need to remove the board from the matrix
switcher.
■ Displaying WJ-HD500 Series
SETUP MENU
To display WJ-HD500 Series SETUP MENU, follow the pro-
cedure below.
1. Confirm that WJ-HD500 Series is correctly and securely
connected.
2. Select the desired monitor. (Refer to p. 3 Monitor
Selection.)
3. Enter the recorder mode. (Refer to p. 19 Recorder
Mode.) Then, the selected monitor number, recorder
number, and "/HDnnn" will appear on the LCD.
Mon4 Cam--
4. Press the MENU button repeatedly until "System Setup"
appears on the LCD.
System Setup
On
5. Press the F1 button.
WJ-HD500 Series SETUP MENU will appear on the
active monitor, and "B" mark will light up beside "On".
System Setup
5On
6. Perform the camera setting while watching the setup
menu on the monitor.
The following functions and buttons are valid in SETUP
MENU.
18
R4
/HD500
501
Off
501
Off
<Main unit>
JogDial clockwise: Increments a parameter.
JogDial counterclockwise: Decrements a parameter.
CAM (SET) button: Executes the selections and dis-
plays a submenu.
+ button: Increments a parameter.
– button: Decrements a parameter.
MON (ESC) button: Returns to SETUP MENU or the
previous menu.
<3D joystick unit>
3D joystick upward (D): Moves the cursor up.
3D joystick downward (C): Moves the cursor down.
3D joystick leftward (A): Moves the cursor to the left.
3D joystick rightward (B): Moves the cursor to the
right.
6. To end the setting and return to the normal view, press
the F2 button while SETUP MENU is displayed. "B"
mark will disappear from the LCD.