Table of Contents
Advertisement
5 Use the 3 mm hex key to loosen the screw
screw.
NOTE: Garmin recommends tightening the screw so the mount arm is secure, with a maximum torque
specification of 20 lbf-in. (2.26 N-m). You should check the tightness of the screw periodically.
6 If necessary, use the 2 mm hex key to remove the two screws on the back side of the mount
rotate the connector, and replace the screws to change the orientation of the mount.
7 Replace and tighten the screw on the handlebar connector.
NOTE: Garmin recommends tightening the screw so the mount is secure, with a maximum torque
specification of 7 lbf-in. (0.8 N-m). You should check the tightness of the screw periodically.
8 Align the tabs on the back of the Edge device with the bike mount notches
9 Press down slightly and turn the Edge device clockwise until it locks into place.
72
on the mount arm, position the mount arm, and tighten the
, remove and
.
Device Information
Advertisement
Table of Contents
