ProForm 900E User Manual page 10

The scan
mode—
Repeatedly
press the
mode button
until an arrow
appears under
the scan sym-
bol. When the
scan mode is
selected, the console will display the speed, time,
distance, watts and calorie modes, for 5 seconds
each, in a repeating cycle.
The speed,
time, distance,
watts, or calo-
rie mode—
Repeatedly
press the
mode button
until an arrow appears below or above the
desired mode symbol. Make sure that there is not
an arrow under the scan symbol.
To reset the display, press the on/reset button.
5
Turn off the power
To turn off the power, simply wait for about
six minutes. If the pedals are not turned and the
console buttons are not pressed for six minutes,
the power will turn off automatically.
All manuals and user guides at all-guides.com
Mode
Arrow
Mode
Button
Mode
Arrow
HOW TO SELECT KILOMETRES OR MILES
The console can
display distance
and speed in either
kilometres or miles.
If a "KPH" appears
in the display, dis-
tance and speed
will be shown in
kilometres; if a
"KPH" does not
appear, distance
and speed will be
shown in miles.
To change the unit
of measurement,
first remove the
four screws attach-
ing the console
(see drawing 1). Lift the console a few inches and turn
it over, being careful not to pull on the wires. Next,
look into the hole below the battery door, and locate
the small switch (see drawing 2). (Note: It may be
necessary to look into the hole and to the left side to
find the small switch.) Slide the switch up or down to
change the unit of measurement. re-attach the con-
sole with the four screws.
10
1
Screws
2
Battery
Switch
Door