Table of Contents
Advertisement
Construction
Hydraulic Ram
Diameter
Air Pressure Range 80 - 120 PSI
Air Inlet Thread
Overall Dimensions
nOte: All part numbers mentioned in this manual refer to the Parts List on page
10 and the Assembly Diagram on page 11.
This lift is designed to be used in conjunction with an automotive lift (not includ-
ed), or in a situation where guide rails have been installed in a shop floor. The
Roller Guides (19) may be adjusted to run on parallel steel tracks between 39-½"
and 55-3/8" apart. cAutiOn: To prevent the Rolling Jack from coming off the
ends of the tracks or falling from the lift, appropriately sturdy stops must be placed
on all four ends of the tracks or rails on which this jack will be used.
You will need the manual for the safety warnings and precautions, assembly
instructions, operating and maintenance procedures, parts list and diagram. Keep
your invoice with this manual. Write the invoice number on the inside of the front
cover. Keep the manual and invoice in a safe and dry place for future reference.
wArning: when using tool, basic safety precautions should always be fol-
lowed to reduce the risk of personal injury and damage to equipment.
read all instructions before using this tool!
Keep work area clean. Cluttered areas invite injuries.
1.
2.
Observe work area conditions. Do not use machines or power tools in damp
or wet locations. Don't expose to rain. Keep work area well lit.
Keep children away. Children must never be allowed in the work area. Do not
3.
let them handle machines, tools, or extension cords.
store idle equipment. When not in use, tools must be stored in a dry location
4.
to inhibit rust. Always lock up tools and keep out of reach of children.
SKU 94835
For technical questions please call 1-800-444-3353
specifications
Formed and welded steel
1-1/2"
1/4" x 18 NPT
55-3/8" L x 18-3/8" W x
23-1/4" H
intended purpose of this lift
save this manual
safety warnings and precautions
Maximum Lift
Capacity
Vertical Travel
Pump Actuation
Roller Assembly
Width
Net Weight
6000 lb. (3 Tons)
10.6"
Foot Pedal
Minimum: 39-1/2"
Maximum: 55-3/8"
302 lb.
Page 2
Advertisement
Table of Contents
