Table of Contents
Advertisement
5.
Press the "PUMP" portion of the Pedal (26) to raise the Lift Pads (1) enough
to contact the lift points of the vehicle. Confirm that you have good contact in
the right spot. If necessary, lower the jack and adjust the position of the Lift
Pads before proceeding.
6.
With the Lift Pads in the correct position, press the PUMP portion of the Foot
Pedal long enough to raise the vehicle approximately one inch, just enough
to take the weight of the vehicle on the jack. Check to be sure the load is
balanced, and that by further lifting there is no danger of damage to the
vehicle or to any nearby tools or property.
.
After ensuring that it is safe to do so, press the PUMP portion of the Foot
Pedal to raise the vehicle to the desired height.
8.
Place safety jack stands (not included) under the vehicle to prevent the
vehicle falling in case the jack should lower unexpectedly.
wArning: never go under a raised vehicle unless there are safety jack
stands in place.
nOte: This jack is intended for temporarily lifting and lowering a vehicle or
similar work load. It is not for storage or for transporting loads. Do not leave
an item on the jack for an extended period of time, damage to the jack or to
other property may result. Do not attempt to transport any load on this jack,
severe personal or property damage may result.
9.
To lower the vehicle, first ensure that all persons, animals and property are
safely away from the vehicle. Be sure nothing is near the scissor assembly.
Remove the safety jack stands.
10. Lower the vehicle by pressing the "ReLeASe" portion of the Pedal Assembly.
Control the speed of lowering to ensure safety and that the vehicle will rest
solidly on the ground.
11. With the vehicle safely on the ground, push the Adjustable Arms (4) back
into Top Strut (10).
12. Disconnect the air hose, and place the air hose clear of the vehicle.
13. Drive the vehicle off the Jack.
SKU 94835
For technical questions please call 1-800-444-3353
Page 8
Advertisement
Table of Contents
