Table of Contents
Advertisement
purging the Hydraulic ram
NOTe: Before first using this tool, the hydraulic ram must be purged.
1.
To purge the Ram, first raise the Jack to its uppermost position, with no load.
2.
When the Jack has been raised, remove the Filler Bolt from the Hydraulic
Cylinder. Keeping your hands and tools clear, press the Foot Pedal down to
attempt to raise the jack even higher.
3.
When it is clear the Jack will not raise any higher, release the Foot Pedal.
4.
Add good quality hydraulic oil into the opening in the Cylinder where the
Filler Bolt has been removed. Fill until the Cylinder will hold no more oil.
5.
Replace the Filler Bolt and its Seal Washer into the Cylinder, tighten firmly.
Lower the Jack by pressing the ReLeASe portion of the Foot Pedal.
6.
Check the condition of the Hydraulic Lift Table before each use. Raise and
lower it several times before adding any load. Be sure that all controls work
properly, and that it raises and lowers smoothly.
nOtice: this jack is not to be used for any aircraft purpose.
1.
Observing all safety precautions, drive the work vehicle over the Rolling Bridge
Jack. Shut off the engine, put the vehicle in gear or park, and set the parking
brake.
2.
Connect your air hose to the male air quick-release adapter. Check that your
air pressure regulator is set between 90 and 120 PSI.
3.
Roll the Jack along its rails until it is positioned properly under the vehicle.
4.
Pull out each Adjustable Arm Assembly (4) to position the Lift Pad (1) where
desired under the vehicle. cAutiOn: Check with the vehicle manufacturer to
determine approved lift points for each vehicle. Never attempt to lift a vehicle
using unapproved lift points, or if the lift points are damaged or weakened by
rust. Damaged or improper lift points may cause the vehicle to suddenly fall
off the jack potentially causing serious personal or property injury.
SKU 94835
For technical questions please call 1-800-444-3353
Operating the rolling bridge jack
Page
Advertisement
Table of Contents
