Using A Memory Card; Recording On The Memory Card - Panasonic AG-EZ50UP Operating Instructions Manual

3
3
PHOTO
SHOT
¿
F 7 1488
2
PUSH
VOL/JOG
PHOTO
SHOT
TAPE CARD
1
MENU
PUSH
VOL/JOG
34

Using a Memory Card

ª Inserting a Memory Card
Before inserting a Memory Card, be sure to turn the Camera/Recorder off.
1, 2
1
Slide the [OPEN] Lever to the right and open the Card Slot
Cover.
2
While holding the Memory Card with its cut corner facing
right, insert it into the Card Slot.
3
Close the Card Slot Cover.
ª [ACCESS] Lamp
While the Camera/Recorder is accessing the Card (reading, recording,
OPEN
playback, erasing, moving of images), the [ACCESS] Lamp
≥While the [ACCESS] Lamp is on, never attempt to open the Card
Compartment, to pull out the Card, to turn off the Camera/Recorder power,
or to switch the [TAPE/CARD] Selector. Such actions will damage the Card
and cause the Camera/Recorder to malfunction.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

Recording on the Memory Card

Still pictures can be recorded on a Card from the Camera/Recorder lens as
TAPE CARD
well as from scenes that have already been recorded on a cassette.
1
The size of images that are recorded using this Camera/Recorder is
approximately 1,680,000 pixels, and recording of images with a size that is
larger than a million pixels is called mega-pixel still-picture recording.
Compared to images of normal recording, images that are created by
mega-pixel still-picture recording can be printed out clearer.
ª Card Photoshot
Recording a picture through the Camera/Recorder lens
(CAMERA Mode)
1
Slide the [TAPE/CARD] Selector to [CARD].
2
Set [PICTURE SIZE] on the [CARD SETUP] Sub-Menu to
[1488t1128] or [640t480].
≥If you select [1488t1128], you can take pictures with higher resolution.
(Mega-Pixel Recording)
3
Press the [PHOTO SHOT] Button.
≥The [ø] Indication will light in red.
MENU
During Card Photoshot recording, the following functions are
disabled.
≥Digital Zooming (l 22)
≥Digital Effect Functions (l 26, 27)
≥Title In/Creation (l 37)
BACK
≥Frame Mode (l 21)
LIGHT
≥The Camera/Recorder is automatically turned off when you leave it for
about 5 minutes without performing any photoshot recording.
≥When recording dark scenes, set [LOW LIGHT SHOT] on the [CARD
SETUP] to [AUTO] and then record. (l 48)
Recording from a cassette (VCR Mode)
1 Slide the [TAPE/CARD] Selector to [CARD].
2 Start playback and press the [PHOTO SHOT] Button at the
scene you want to record.
≥The size of the images input externally or recorded from a tape to the
card becomes [640t480].
≥While the image is being recorded, it stays still for a few seconds.
≥Please refer to "Recording to a Card from other equipment" (l 48),
regarding the recording to a card from other equipment.
Selecting the quality of Card Photoshot images
1
Set [CAMERA FUNCTIONS] or [VCR FUNCTIONS] >> [CARD
SETUP] >> [REC MODE] >> a desired image quality (FINE,
NORMAL, ECONOMY).
1
lights up.
1