Hitch And Frame Installation - Briggs & Stratton LT 125 Operator's Manual

Assembly
Before beginning any service work turn
WARNING:
off the PTO, set the parking brake, turn off the ignition,
and disconnect the spark plug wire(s).
Hitch and Frame Assembly
1. Slide the 5/16-18 speed nut (A, Figure 2) onto rear frame
support (E) through square hole (C) so that the threaded
side (B) is on the inside of support.
2. Install the 5/16-18 shoulder bolt (D) as shown.
3. Repeat on the other side.
E
Figure 2
4. Slide the hitch (A, Figure 3) onto the right and left shoul-
B A
Figure 3
C
D
6
der bolts (B) of the rear frame support (C) .
B
C
A
B