Table of Contents
Advertisement
FRAME & BAGGER SUPPORT ASSEMBLY -
All Models
Note: Units with 0510 transmissions use anchors (A, Figure
7) with a notch, all other units use anchor with no notch.
See Inset Figure 7.
1. Remove the existing bolts from each of the transmission
housing brackets.
2. Assemble the two anchors (A, Figure 7) to the
transmission housing brackets using the 5/16-18 x 3"
capscrews (B), washers (C) and nuts (E). Install the
capscrews from the bottom of transmission. Do not
tighten hardware at this time.
3. Position support assembly (F, Figure 7) on anchors and
secure to rider over the hitch with safety clip pin (G) and
round pin (D).
4. Fully seat each anchor into the support assembly tubes
and square up bagger frame with rider frame. Tighten
anchor mounting hardware securely.
5. Place catcher support (H) into support assembly as
shown (Figure 7).
H
F
E
A
C
B
0510
Transmssion
Models
(Notch)
Figure 7
D
G
All Other
Models
(No Notch)
GRASS CATCHER ASSEMBLY -
Note: Cover and bag support are packaged as an assembly
with long clevis pins and clips. It may be easier to separate
components for the following step.
1. Install horizontal bag support (A, Figure 8) to upright
catcher support (B) holes as shown. Note that there is
one open set of holes (D) toward the discharge side of
mower. Install four 3/8-16 x 7/8" capscrews (C) from the
front and lightly secure with flange lock nuts.
2. Make sure bag support and catcher support are square,
then tighten flange lock nuts.
Figure 8
3. If Not Pre-assembled:
Install grass catcher cover (A, Figure 9) to support (B)
and secure with clevis pins (C) and clips (D).
Figure 9
Assembly
All Models
D
C
C
A
B
A
D
B
7
Advertisement
Table of Contents
