Video Equipment Connections - Onkyo TX-DS474 Instruction Manual

Video equipment connections

On each pair of input jacks, a red connector (marked R) corresponds to the right
channel, and a white connector (marked L) to the left channel.
A yellow connector (marked V) is used for video connection.
Please refer to the instruction manual of each component when making any con-
nections.
AUDIO OUTPUT
VIDEO OUTPUT
ANTENNA
(REC)
AM
TAPE
(PLAY)
FM
75
DVD
VIDEO-1
GND
OUT
L VIDEO-2
I N
R
PHONO CD
AUDIO IN
AUDIO OUT
Video Cassette Recorder
Notes:
When using a playback-only VCR, you need to make only the output connections.
This receiver can be used with only a monitor TV equipped with a video input jack.
Interference may be caused between the TV and this receiver. If this interference occurs, place the receiver and the TV as far apart
as possible. We do not recommend the use of a common TV/FM antenna (see antenna section).
A DVD or other component equipped with a digital output can be connected to this receiver. The digital connection must be used in
conjunction with an analog connection, because if the analog cable is disconnected, the audio output from TAPE OUT and VIDEO-2
will not work.
Remove the protective cap attached to the DIGITAL-1 (OPTICAL) jack before making the connection. When this jack is not used,
replace the protective cap.
DVD Player
DIGITAL COAXIAL OUTPUT
DIGITAL OPTICAL OUTPUT
SUB
MULT I CHANNEL
WOOFER
I NPUT
PRE OUT
R L
R L
FRONT
OUT
SURROUND
MONI-
TOR
OUT
I N
I N
SUB
CENTER
WOOFER
FRONT SPEAKERS
I N
A B
L
R
R L V
VIDEO IN
VIDEO OUT
Digital audio connections
This receiver has a powerful digital signal
processor for use with DVD players, DAT
decks, and CD players. The digital inputs,
DIGITAL-1 and DIGITAL-2, can be assigned
to individual input selector buttons, so when
an input selector button is pressed, the
assigned digital input is used instead of the
corresponding analog input. (See page 17.)
CENTER
SPEAKER
L L
SURROUND
SPEAKERS
R R
L
MODEL NO. TX-DS474
R
VIDEO IN
Monitor TV
Audio connection cable
L (Left)
R (Right)
Video connection cable
V (Video)
DIGITAL INPUT
DIGITAL 2
(COAXIAL)
DIGITAL 1
(OPTICAL)
AC OUTLETS
AC 230V 50Hz
SWITCHED
REMOTE CONTROL TOTAL 100W MAX.
: signal flow
L
R
V
7