Using Preset Radio Stations - Onkyo TX-DS474 Instruction Manual

Using preset radio stations

SCAN
GROUP
STANDBY/ON
STANDBY
POWER
SCAN GROUP
ON OFF
A SPEAKERS
MUL TI CH INPUT
PHONES
√ PRESET ®
2
SPEAKERS A
MEMORY FM MUTE / MODE
CLEAR
3
SPEAKERS A
SCAN GROUP
4
PRESET
SPEAKERS A
MEMORY FM MUTE / MODE
5
FM AM
1
2
SCAN GROUP
3
PRESET
SCAN
or
MEMORY FM MUTE / MODE SPEAKERS A
CLEAR
√ TUNING ®
AM
FM
MASTER VOLUME
PARAMETER SELECTOR
PARAMETER CONTROLLER
PRESET TUNING
HIGH CURRENT DISCRETE OUTPUT STAGE AMPLIFIER
B SURROUND MODE MIDNIGHT THEATER DIMMER MEMORY FM MUTE / MODE
CLEAR
BASS
DVD VIDEO 1 VIDEO 2 TAPE( MONITOR ) FM AM PHONO C D
AUDIO VIDEO CONTROL RECEIVER
MEMORY
FM MUTE/MODE
FM MUTE TUNED FM STEREO GROUP
A
2
VIDEO MEMORY
MHz
FM MUTE TUNED FM STEREO GROUP
2
VIDEO MEMORY
CH
MHz
FM MUTE TUNED FM STEREO GROUP
VIDEO 2
MHz CH
CLEAR
Remote controller
TUNER
Remote controller
GROUP
Remote controller
PRESET
GROUP
FM MUTE TUNED FM STEREO GROUP
VIDEO 2
MHz CH
GROUP
TREBLE
TX-DS 474
Programming radio stations
1. Select the frequency that you want to store in the memory.
(See Tuning in a radio station on page 22.)
CH
2. Press the MEMORY button.
The MEMORY indicator will light up for eight seconds.
3. While the MEMORY indicator is lit, press the GROUP but-
ton to choose the desired group.
The group shown on the display changes in the following order
B
each time the button is pressed:
GROUP A
4. Select the desired memory number using PRESET √/®
button.
5. Press the MEMORY button.
B
Since ten AM or FM stations can be stored in each group (A, B
or C), a total of 30 stations can be stored in the memory.
Selecting a preset station
1. Select the tuner as the source by pressing the AM or FM
input selector button on the main unit.
2. Press the GROUP button until the desired group is dis-
played.
3. Enter the desired preset number using the PRESET √ and
® buttons or press the SCAN button to scan through the
preset stations.
If the SCAN button is pressed, each station stored in the
selected group will be played for five seconds. When the desired
station is found, press the SCAN button again to stop scanning.
Remote controller operation
1. Select the tuner as the source by pressing the TUNER input
selector button on the remote controller.
2. Press the GROUP button until the desired group is displayed.
3. Press the PRESET (√ or ®) button.
Cancelling preset stations
1. Select the preset station you wish to remove as explained in
B
the previous section.
2. Press the FM MUTE/MODE button while holding down the
MEMORY button. "– –" appears on the channel display.
Once the preset station has been cancelled, the memory location
can be used to store another station.
SUR MULTI-CH
POWER
SLEEP DIMMER MODE INPUT
TUNER
INPUT SELECTOR
DVD TAPE TUNER PHONO C D
TUNER √ PRESET ®
VIDEO-1 VIDEO-2 GROUP PRESET
C D DVD
DISC
TAPE
CH SEL
TEST
TONE
LEVEL VOLUME
MUTING
REMOTE CONTROLLER RC-385S
GROUP B GROUP C
23